LABVIEW EUROTHERM DRIVER

Do a search on RS bias resistor on the NI sites and you should get a document that explains about this. I also spent quite a bit of time for setting up Eurotherm RS Comm. Message 2 of 6. Some of the NI plugin boards do have programmable bias resistors that can even be switched on and off through a VISA attribute node if I’m not mistaken. The unit I got from the client to do some testing in our office appeared to be defect, and testing in the factory installation is a hassle. Now I have a strong suspicion that the Eurotherm driver you downloaded was actually developed and tested with a controller with RS interface.

Uploader: Togul
Date Added: 5 March 2006
File Size: 47.34 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 31273
Price: Free* [*Free Regsitration Required]

Now I have a strong suspicion that the Eurotherm driver you downloaded was actually developed and tested with a controller with RS interface. I hope this information will help you make your system work. Instructions for that are here: I encounter a problem with my project. Message 6 of 6. What did work is to replace the RS interface in the controller with a RS module and connect it to an RS port on the compactFieldpoint.

Message 5 of 6. Unless your interface card has these resistors built in, it is likely the problem why you can’t get this work. Also, just wonna make labbview that whether the serial port I am using is compatible.

  F1U201 BELKIN DRIVER

This was not possible to get working although I didn’t have a chance to go very deep into debugging with this. The REM lbaview flash when there is a connection however I cant get it flash so I assume the problem is in connection.

Eurotherm nanodac Controller – Ethernet Driver for LabVIEW – National Instruments

I found that terminal registor cause significant voltage drop, so I do not use any termial registor. Another solution we also successfully used was to place an Eurotherm KD converter between the RS interface on the computer and the RS interface in the Eurotherm controller.

Most Active Labvifw Boards: Is it really necessary for me to use the serial port from NI instead of using random brand serial port? Some of the NI plugin boards do have programmable bias resistors that can even be switched on and off through a VISA attribute node if I’m not mistaken.

Sounds like we have quite a few different things going on here, so lets backtrack a bit and see where were getting the communication issues. I also spent quite a bit of time for setting up Eurotherm RS Comm.

Rolf Kalbermatter Averna BV.

Can anyone give me a hand? Applications Engineering National Instruments. The unit I got from the client to do some testing in our office appeared to be defect, and testing in the factory installation is a hassle. Thanks for the reply The loopback works well and the LabVIEW driver I am using is directly downloaded from NI website et24xx so it can be assumed that the problem is not on the code?

  INTELLIMOUSE MODEL 1001 DRIVER DOWNLOAD

However time and other constraints did not allow us to debug that deep enough to make it work as a full RS connection. Do a search on RS bias resistor on the NI sites and you should get a document that explains about this.

We primarily host it for convenience. Or should I euritherm the eurothrm protect from NI? Message 3 of 6. On software configuration, here is the list. Also, the et24xx driver maybe shouldn’t be labvie to work.

Labview Driver now Available for Eurotherm nanodac

Message 1 of 6. Message 4 of 6. Message 2 of 6.

Also, I am thinking if the issue is due to the incorrect serial port I am using. With this configuration, I made it work.

The Eurotherm controllers can be delivered with either RS or RS interface it’s a module that can be replaced inside the controller. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.